12 Dec. 2010|
Build wood shelves for shed,how to make a toy doll house,john deere bunk bed building plans,outdoor swing bed plans - For Outdoors
We use our Bosch job site table saw and a Craftsman circular saw to make the two cuts for our plywood surface. The top plate of the wall is exposed in this style shed, and we decided we wanted our plywood shelf to cover it.
Stay tuned in the next few weeks for the shelving on the other side of the shed, and some nifty latching hooks we’ll be installing on the back of the shed to hang our shovels, rakes, and other gardening and lawn tools.
If you want a backsplash, you might consider installing peg board on the back wall before installing the shelves.
It looks great on the outside, but without some shelving and storage hooks for tools inside, most of the interior space would go to waste. This helped us try out different articles to make sure the shelving heights worked for our storage goals. The table saw makes quick work of the rip cut, but the circular saw is a little easier to manage for the shorter cross-cut. We want the shelf to have a nice fit and finish, and getting the cuts right is essential for this.
We also decided that this shelf would be easier to install in place, rather than building it outside. We should’ve snapped a pic before piling everything in the shed, but with the heat still beating down on us, we rushed the completion. Changes in Google’s search algorithms coupled with the rise of literally thousands of home improvement-focused sites have made competition for readers fierce. So we collectively decided it was time for him to pursue new interests so he could make sure his family is taken care of! It certainly isn’t the future that we had hoped for with the site, but the site was a fantastic success for years, and we feel very proud that we were able to contribute in such a cool way to the web ecosystem. But fear not, the heat didn’t deter us from tackling our long-awaited shed storage shelves project. On deeper shelves where weight isn’t a major concern, 2x4s can be run front-to-back to avoid plywood sag. We measure below the surface of the top plate to find the right spot for the support 2×4.
They’re hanging off the wall and the ceiling, so I used lag bolts instead of just wood screws.
I generally use a Senco screwgun for anything major and I believe they do have the torx head drivers for those as well, but phillips seem to work pretty well (have to change the bit every couple hundred screws).
These screws are more than sufficient for the weight loads we’ll be putting on these shelves. So starting with the smaller shelves meant we didn’t have any waste or have to make extra cuts. For a deep shelf, a third 2×4 could be placed at the middle of the shelf spanning side-to-side parallel to the front and back.
They tons easier to drive and much more forgiving if you aren’t perfectly lined up straight.