Thickness planer snipe, purple heart wood ring - With Secrets

Categories: Wooden Work Bench | Author: admin 15.09.2013

Planer snipe is a common phenomenon with almost all planers and its one truth one cannot run away from. In the case of some small thickness planers, the main cause of planer snipe is the movement of the cutter head assembly however this can be eliminated by having a locking mechanism with the cutter assembly. The unbalanced pressure exerted by the rubber rollers is the main cause of planer snipe, which is normally experienced at both ends of the work piece.
When the work piece is introduced to the planer, the blades work on the piece while held by only one rubber roller after which it is held by two rubber rollers and thus equal pressure at both ends of the work piece. But if not, then either you have never been keen or never bothered to find out if snipe does exist.


Normally when a planer is used there are two conditions, which are normally experienced at the two ends of the work piece. In contrast, at the out-feed, a situation arises when wood is held by only one rubber roller and hence unbalanced pressure which ultimately results into a planer snipe. Alternatively, use a discarded piece of wood in front of the actual work piece so that it takes the brunt of snipe at both ends. People make a huge fuss about it but snipe is so minor that the average individual doesn’t need to know. However, planer snipe is normally experienced much more at the in-feed rather than at the out-feed.


If you really want to find out then running a finger over the board or shinning light at an angle can help determine snipe.




Plans for wood outboard motor stand
Wood dust collector parts


Comments: