Pvc dust collection plans, beginner hand tool woodworking projects - Reviews

Categories: Woodworking Shelf Plans | Author: admin 25.03.2012

When I installed a central ductwork system for my dust collector, I used 4" PVC pipe instead of steel and saved 75 percent on the cost. To soften the PVC for the joints, we slipped a hose clamp over the pipe and carefully heated the pipe until it softened.
A central dust collection system provides the most convenient means for connecting a dust collector to several pieces of equipment. Air and wood particles moving through the dust collection system quickly build up static electricity charges in any nonconductive hose or piping (hose or piping not made of metal). Try heating the duct work slightly and inserting the dust collection fittings into the duct work.


I purchased the drain and sewer pipe along with fittings to connect the pipe but have a problem getting the fittings to match any of the standard dust collection fittings available through known outlets. With the pipe end soft, he slipped the fitting into the pipe, slid the hose clamp up near the end, and tightened it to snug-up the softened PVC end.
With no tape, glue, or steel, and only a single hose clamp, it's a clean, simple way to build an inexpensive but effective collection system.
When this static buildup discharges, it could lightly shock the operator or even ignite the flammable wood dust particles inside the piping. The other end should extend to the outlet port on the tool, but it doesn't need to connect to anything, except to keep it in place.


Simply strip the plastic away from a few inches of the wire core, then connect the wire to your system ground, as shown in the illustration.



Hope chest plan
Quilt rack wood plans
Vertical plan cabinets perth
How to build rustic wood headboard


Comments: