How to apply wood veneer to melamine, free boat shelf plans - How to Do

Categories: Wooden Work Bench | Author: admin 09.10.2013

Hardwood edging can be a simple as gluing a wood strip to the edge of the plywood and flushing cutting the top edge to the plywood surface.
If the project calls for a basic straight edge on the plywood, veneer edge banding may be just what the doctor ordered. If you are applying the edge banding to two joining sides, its best to work with the least visible side first. Veneer edge banding can be stained and finished with any conventional wood finishing products including lacquer, danish oil, and oil based stain and polyurethane. To get the best bond possible, pressure should be applied behind the iron with a block of wood.


To fix this, simply use the block of wood (held at a 45 degree angle) to press the edge back onto the substrate while the adhesive is still warm. Be sure to skew the chisel so that the pressure forces the banding against the wood edge as shown.
Or if you prefer a micro-beveled edge, you can use a sharp block plane or sandpaper wrapped around a wood block.
Use scissors (for paperbacked veneer) or a veneer saw (for 2-ply and raw wood veneer) to cut your own edgebanding from the veneer stock used on the other parts of your veneered panel. These zig-zag lines occur randomly throughout the roll and are mostly invisible if you are only applying a clear coat.


With heat from a clothes iron, you can bond any non-glued edgebanding, including one cut from a piece of veneer to any porous substrate.



Sanding wheels woodworking
Best buy wood lathe
Wood carving knives sharpening
Monks bench plans


Comments: