Harvest table plans lowes, wooden boot drying rack - With Secrets

Categories: Woodworking Plans Corner Desk | Author: admin 20.04.2013

Before starting on your table and benches, obtain the pipe fittings in advance to ensure you’ll have adequate materials on hand to begin.
Organize the pipes and fittings needed to begin the table on a large work surface (Pipe-Frame Table Project Diagram, Cutting List and Drawing 1). Cut five 2 x 8 boards to 84 inches long for the top slats (A) (Pipe-Frame Table Project Diagram, Cutting List). Place the top slats (A) on a work surface and position the middle cleat (B) so that it is centered on the bottom face of the top, (Pipe-Frame Table Project Diagram, Drawing 4). Good to KnowThe table can be made shorter or longer by substituting pipes of a different length in the base assembly.
Place the top slats (A) on a work surface and center the middle cleat (B) on the seat slats.
Turn rough construction lumber into top-notch material to make this affordable table and bench set. For the remaining table base parts, cut the long aprons B, short aprons C, corner braces D, and stretchers E to width and length.
Glue the corner braces into each corner of the table; reinforce by driving 2" pocket-hole screws through the blocks into the aprons as shown -- no pocket holes are required. Complete the table base assembly by adding the stretchers between the long aprons using glue and pocket-hole screws.


When the stain is dry, brush on three coats of a semigloss polyurethane to the table base and slats. Place a couple of sanded scrap 2"x4"s on the floor , and lay your slats on them with the best face down. Center the table assembly on the slats and secure the table base to the slats (Photo 3) with 2" pocket-hole screws through the aprons and stretchers.
For the benches, use the same procedure to prep the materials as you did with the table: Cut the part 1" longer than called for, trim to width, and then cut to final length. Place one of the seat slats on the bench so the edge of the slat is aligned with the ¼" gap between the legs (Photo 4) and centered end to end on the bench.
Continue joining the fittings and pipes as shown (Pipe Frame Table Project Diagram, Drawing 1).
These fittings should be very loose at this time (Pipe-Frame Table Project Diagram, Drawing 1).
Repeat for the three remaining leg assemblies (Pipe-Frame Table Project Diagram, Drawing 2). Rest the table base on the top (Pipe-Frame Table Project Diagram, Drawing 5) and adjust the pipe frame until it rests squarely on the top. If you want to add a foot in length to the table, substitute two 24-inch pipes for the 18-inch pipes.


Using a table saw, trim the leg blanks to final width and thickness; using a miter saw, trim the parts to final length (Cutting List, Cutting Diagram).
Start the process by easing all of the hard edges of the top and table base with 220-grit sandpaper for a smooth feel. No Problem!If you don’t have a table saw, you can still create the table and benches. If the specific length pipe is not available, a Lowe’s associate can cut and thread the pipe for you.
If a specific pipe is not available, a Lowe’s associate can cut and thread pipes for you. With a few modifications to the plans -- and a lot more sanding -- you’ll be ready to go. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.



Woodcraft router table
Carpentry joints pictures


Comments: