Adjustable shelf plans, woodworking making cabinet doors - With Secrets

Categories: Woodworking Projects For Beginners | Author: admin 16.06.2012

How to Build an Adjustable-shelf Bookcase - Bookcase Projects - Built-ins, Shelves & Bookcases. This adjustable-shelf bookcase includes double-wall construction with concealed edges and flush sides.
Post your projects & plansShare your projects and plans with others in the Start Woodworking community.
The physics of it seem to work: The notches support the shelves and hold quite a lot of weight. Remember that these shelves still need to be sanded and that it doesn't take much for these shelves to be too loose.The next step is to install some metal hangers in the top back of each upright. Although I have seen many commercial versions of wall-hung shelving systems built of wood, I wanted something cleverly uncomplicated (if you know what I mean) . A spline inserted into the back of each upright stiffens them so they do not bend, and matching notches in the backs of the shelves keep them from moving side to side.


I find it's more efficient to do the bulk of the jointing, planing, ripping, and crosscutting work at the same time.The Uprights1. So whether you're a beginning builder or a veteran, these bookcase and shelf building tips will lead to beautiful results with less time and effort.
As long as the shelves fit the notches just right and weren't too deep or heavily loaded, it should be fine. You will need to choose a flush hanger, however, to allow the shelves to hang flat against the wall.
When you screw these flexible pieces of wood to a not-so-flat wall, the notches either spread open or pinch closed just enough to make the shelves either too loose or too tight in their slots. I finished my shelves with a satin spray lacquer, but as with many of the projects in this book, a good-quality oil finish or even a carefully applied brush-on water-based polyurethane would also work well.
The splines do not need much to keep them in place; if you put too much glue into these joints it will only end up squeezing out in the dadoes and around the visible portions of the splines, which will be extremely difficult to clean up!7.


Once the splines are fully seated, place some clamps along the joint to make sure it remains tight until the glue dries.9. A sharp handsaw for the ends and a block plane for the back will make short work of this.1.
Using a miter gauge with a tall auxiliary face attached to support the shelves, cut a notch in each end of the back of all the shelves.4.
Take these still slightly thick shelves and plane them down until they fit easily into the notches of the uprights.



Wood spiral staircase plans
Wood model ship building kits
Diy corner entertainment center plan
Free furniture diy plans
Tree stand plans wood


Comments: