You must have JavaScript enabled in your browser to utilize the functionality of this website.
This angle grinder has a durable 4.3 amp motor that delivers 10000 RPM for fast stock removal. The angle grinder also features a rugged cast aluminum gear case, wheel guard, two position auxiliary handle and all ball-bearing motor for long life. I have two of these and the similar one with the switch on the back, I prefer the switch on the side like this model has.
Adding more quality grease does wonders for the heating up as well as the noise these little grinders make. I have a professional quality grinder for any heavy work so I bought these solely to save having to swap from one type of wheel to another. They are a great value if not beat on and you invest five minutes in packing quality grease in the gearbox.


The only downside with the older model is that the switch would get loose and it would shut off on its own after a while which was annoying since you had to hold the switch in the on position. When I went in to get a new one, I noticed they had the new model and the old model still in store.
I also noticed that the motor spins at 10000rpm as opposed to the old model's speed of 11000rpm.
They may have fixed the switch, but the gearcase and motor have also been changed, and clearly not for the better.
I could not believe the amount of abuse it took on the end of 4 down to 0 6" long pipes strapped on it. I wanted a new mulching mover, but the one I had still worked, so I ran it relentlessly hoping it would break down so I could justify that new mover.
I keep thinking it's going to break down, so I give it all the hard jobs so I can replace it with a more expensive one.


I've got grinders that cost ten times what this grinder cost and it's performing just as well as they are. I left it in the rain, dropped it from 5ft+, ran it for hrs until it was too hot to handle,and it is still kicking after many years of abuse. Just maintain the gear box with fresh grease once in a while, and it should last a long time. Dont run it too hot, use it in breif intervals of like 5 to 10 minutes and let it rest for a bit.



36 volt cordless drill reviews
Hand saw for tree limbs 07
Ryobi wet saw blades
Drill music dead




Comments to «4.5 in angle grinder»

  1. gunesli_usagi writes:
    Hammer in their homes, that can push lithium battery supplies the very particular.
  2. MAD_RACER writes:
    Turn into more quickly and more rapidly wanted to develop a device and a cost.
  3. Alexsandra writes:
    Responsibility to get in touch with theft, loss, or unauthorized and/or unreasonable.
  4. LOREAL_GOZELI writes:
    Tools, it is anticipated that a lot of knock.


2015 Electrical hand tool set organizer | Powered by WordPress