The term ignition-off draw identifies a normal condition where power is being drained from the battery with the ignition switch in the Off position. The IOD connector can be used by the vehicle owner as a convenient means of reducing battery depletion when a vehicle is to be stored for periods not to exceed about twenty days (short-term storage). The IOD connector feeds the memory and sleep mode functions for some of the electronic modules in the vehicle as well as various other accessories that require battery current when the ignition switch is in the Off position, including the clock. Simply disconnect the IOD connector from the JB receptacle slot # 15 and place it in slot # 11 (see diagram above).
Refer to Ignition-Off Draw Fuse and Battery in the index in this service manual for the location of additional service information covering the ignition-off draw fuse and the battery. However, it must be remembered that disconnecting the IOD connector will not eliminate IOD, but only reduce this normal condition. When a vehicle will not be used for more than twenty days, but less than thirty days, remove the IOD fuse from the Power Distribution Center (PDC). Just dab a little flux on this joint and heat it with a soldering iron until it melts back together. Slide the relay back into its cover, dab a little super glue or tape it back together, and you're ready to go.



Sas ultimate survival guide online
What is education definition of education
First aid training ppt in tamil
Best english story books pdf online