Woodworking Cutting Board Finish,Power Tool Stands,Plans For Building A Wooden Magazine Rack,Turned Wood Floor Lamps Graham Green - Test Out

09.07.2015, admin  
Category: Dresser Woodworking Plans

Step 13: Finishing and future careThere are two basic ways to finish a cutting board - oil and wax VS varnish. Wash the board with soap and water, but don't let it sit in a wet sink or put it in the dishwasher. It is 100% food safe (actually sold in drug stores as a digestive medicine) and soaks deep into wood fibers to protect cutting boards. Buy the best wood cutting board you can afford, take care of it, and it is likely that your grandchildren will be using it. Ensure that your boards are completely dry before oiling, use a soft cloth to rub oil over the surface, and let them soak it in and dry fully.
Oak wood is a naturally hard wood and functions beautifully as both a cutting and serving surface. The wax will both moisturize and protect, keeping your board strong for your next kitchen creations!


The main disadvantage of mineral oil is that it must be frequently re-applied to keep cutting board protected. To use, simply rub the wax over your board using your fingers or a soft cloth, and removing any excess once the board has been covered. Wood also has natural antiseptic properties and is a great, beautiful alternative to your cutting board’s plastic counterparts.
After planing the wood, jointing, sanding, and finishing it with natural hemp oil and beeswax, the reclaimed wood is even more beautiful than it was 100 years ago!
Too much exposure to prolonged moisture can cause your board to warp or crack, so be sure to clean promptly and do not soak in water. Through the cutting process a mill can create (and waste) planks of wood that are just waiting to be appreciated for their charm, natural beauty, and nonconforming edges. Let it soak in for at least 30 minutes to overnight, then buff your board to a glossy sheen.


Refrain from using any edible savoury oils (such as olive oil) as it may go rancid and cause your board to smell. After the last finishing sanding, your wooden PDL cutting or serving board is bathed in a moisturizing hemp oil bath for 24 hours and left to air-dry for another 24. We recommend every 1-2 months, but keep an eye on your board and if it looks dry simply give it a light coat.



Best Hand Planer
Plans For Wall Mounted Folding Table


Comments to “Woodworking Cutting Board Finish”

  1. GRIK_GIRL:
    These and the process searching for wooden to your woodworking mission, the book shows, the.
  2. rumy22:
    Novices and for more seasoned woodworkers on the lookout for.
  3. ToMeKK:
    Extremely advisable reference for Woodworking Cutting Board Finish varsity and community library, in addition what to do however if you are.