Wood Plane,woodworking projects playhouse sandbox,end table woodworking plans free - PDF Review

12.09.2014, admin  
Category: Woodworking Clock Projects

Whatever the planing task before you or the type of plane to be used, there are some constants.
Most planes work best two-handed, with the left hand guiding the plane at the front, the right driving from the rear.
The iron must be set to plane very fine shavings (thicker shavings will tend to tear the grain).
Step 1Place the board in a vise or clamp it to a workbench so that you can plane along the crooked edge, working with the wood grain. Step 3Set the hand planer flat against the edge of the board and push it in the direction of the wood grain, using long strokes. There you are, just you and, say, a molding plane, standing over a board fixed in place on the workbench.

If you have a crooked board, you will likely need to plane it so that the edges are square and its dimensions are consistent.
Planing against the grain will cause the wood to tear and splinter, giving it a rough edge. The longer the plane, the less it will exaggerate any existing troughs and crests cut into the edge. For hardwoods, begin by planing diagonally to the grain, perhaps at a forty-five- degree angle, more with some hardwoods. Planing a crooked board requires a little more time and patience than planing a straight board, but with the right tools, you can make almost any crooked board straight, although it will lose some of its width in the process.
Test the board with the long level, and make short planing strokes in any high areas until the board is straight.

Use a long-soled bench plane like a jack or, for a large workpiece such as a tabletop, a jointer plane.
If the plane you are using has a depth stop, work until it contacts the workpiece and stops the planing. Before pushing the tool along the length of the board, apply some pressure at the front of the plane to be sure the sole sits flush to the piece (rather than on an incline, with the toe lifted above the piece).
Likewise, be sure the heel sits flush to the board as the plane reaches the end of the planing stroke, shifting some of your weight to the back of the tool.

Cabin Game Ideas
Wood Moisture Meter Home Depot

Comments to “Wood Plane”

  1. azercay_dogma_cay:
    Are actually proud (Mick's Woodworking Instruments web page???) that was attributable.
  2. Rocklover_X:
    For understanding any scrolled patterns are usually not required. throughout the.