Record Woodworking Tools,Pool Table Plans Woodworking,Plans Wood Patio Furniture - How to DIY

16.10.2014, admin  
Category: Woodworking Clock Projects

Some of you have asked to see "the monster", the lathe kept out in the garage for several years just to balance large pieces to the point where I could put them on my Record lathe (Also since departed). The wedges have dowels embedded in them that just fit down into the holes drilled into the toolrest.
In 2001, I started making a few tools of my own to work on the large pieces I am now able to turn on my General lathe. Perhaps this short tutorial on how to use the Termite will help prevent some of the heart-stopping catches this tool is capable of. I called him to ask if he would make me a couple of hollowing tools, and he was kind enough to send me a couple to try out. I use home made wedges like the one shown on the top right photo to sharpen tools that require a different angle, like my scrapers.
It's a wicked tool to learn to use, but once you've mastered it, nothing will do a better job. You can use the tool on the bottom, but only as a skew scraper, turned at least 45 degrees.
With over one hundred years of expertise and experience in the design and manufacture of fine Woodworking Machinery and Tools, Record Power offers a high quality choice of machines and accessories that can be bought with total confidence, offering real value and backed up with long term support and guarantees.


Whether you are a first time purchaser or an experienced woodworker Record Power supply a product of the highest quality to suit your requirements. D&M Tools stock a wide range of Record Power Machionery and accessories and our expert staff will be pleased to advise you on the best tool for your needs. The wedge shown at the bottom right is an example of how you can create tool-specific wedges for sharpening - in this case for a disk tool.
A few years ago I was frustrated by the fact that I could not find tiny pads that would work with my Dremel or Foredom tools to sand tiny spots. The front of the box is deliberately high enough at the front of the wheel so a tool can't inadvertently make contact with the edge of the felt wheel that's coming toward you at the bottom. After making a 56" long holder for my ring cutters, I decided I still needed a couple of very large scraper-type tools to smooth the ridges left from the ring tool on the inside surfaces, so I made the two shown below.
I sharpened these just before I took the picture and it took me less than 3 minutes to do them all. Files are very brittle carbon steel and can snap quite easily if used full length and extended over the tool rest. Record Power, with its long established history and experience in woodturning, offer ongoing support and resources to help your craft develop.The machine featured in this package, the DML18SH, is ideally suited to the ambitious beginner or more serious turner on a restricted budget.


I've got a couple of walnut blanks for 26" deep vases, and to reach to the bottom of those I needed some sizeable tools. It is made by Record tools, and consists of a single sharp disc mounted directly on the end of a shaft.
The wedge shown takes the tool rest to 65 degrees for the scrapers, and another one takes the angle to 90 degrees for parting tools, etc.
Keep in mind; this is not a tool for the faint of heart, 'cause it can give you some heart-stopping catches. The shafts are simply epoxied into the chrome pipe and the pipe fitted into handles of 24" and 28" on the larger tool.



Wood Jointers Planers
How To Make A Wood Mantel Shelf
Bench Plane Setup
Free Woodwork Plans For Beginners


Comments to “Record Woodworking Tools”

  1. SKA_Boy:
    Plugins and still probably isn't completed with the instruments which are for youths.
  2. NEFTCI_PFK:
    Are also included with this unit we're.
  3. DozanQurdu:
    And allowed college students to decide on their different machinery such as the Triton.
  4. 256:
    Out November 2013 and if you'd like to be the first to receive.