Java cfg install,can running cure type 2 diabetes treatment,can diabetics eat sticky rice,drugs for diabetes prevention xp - Good Point


This chapter provides detailed instructions for installing the VDS-OS software on Cisco Unified Computing System (UCS) platforms.
NoteYour screen shots might differ from those shown in this chapter, depending on the UCS platform that you are using. The UCS B200 blade server uses the backplane to connect the Ethernet NIC (eNIC) to the internal switch (IOM), and the hardware does not provide an LED to indicate that the NIC is up or connected. The VDS-OS software installation requires a minimum of two IP configurations, each with an Ethernet cable attached to a switcha€”one to the CIMC UCS Management port and the other to one of the 6 NICs. Step 3Verify that the CIMC interface can be reached by pinging the IP address associated with the CIMC port. If an error occurs, make sure the Ethernet cable is securely connected to the CIMC management port. Step 5When the CIMC login screen is displayed, log in using admin as the username and the default password you set in the a€?Configuring the CIMCa€? section.
Step 6When the CIMC Configuration Utility screen is displayed, press F10 to save the configuration. Step 1On the CIMC login screen, log in using admin as the username and the default password you set in the a€?Configuring the CIMCa€? section. Step 3Verify that CD-ROM and HDD appear in the Configured Boot Order pane in the correct order, then click Save Changes.


Step 2Connect the UCS B200 to the Fabric Interconnect console port and assign the management IP address. Step 3Access the Cisco UCS Manager using your web browser and the IP address of the UCS Manager. Step 6A blade server requires a service policy to achieve external communication through the mezzanine card. Download the VDS-OS ISO file (rescue-cdrom.iso) to a workstation that is used to connect to the CIMC, then mount the ISO file as a Virtual Media. Step 2When the KVM console window is displayed, which can take up to 5 minutes, select the VM tab. Step 3Click Add Image, then browse your workstation's file system, select rescue image and click Open.
Step 5Reboot the UCS by accessing the CIMC Server Summary pane and clicking Power Cycle Server. In the CIMC BIOS pane, confirm that the BIOS boot order matches the order that you configured in the a€?Configuring the BIOSa€? and a€?Configuring the BIOS to Boot from a CD-ROMa€? sections.
You can also power-cycle the server by clicking Power Cycle Server in the CIMC Server Summary pane. Step 2When prompted, enter the default password you set in the a€?Configuring the CIMCa€? section.


The Setup utility takes you through the initial configuration settings for a VDS-OS device. The Management port is labeled a€?Ma€? (the port with the yellow Ethernet cable connection shown below).
Other browsers, such as Chrome or Internet Explorer, might experience problems when the CIMC executes random web-based Java code on your workstation. If they are not set correctly, the CIMC uses network ports other than the dedicated CIMC port, which can cause problems. Once CIMC connectivity is established, you can install the software using the rescue-cdrom.iso file.
KVM must remain open to keep the virtual media mapped and to successfully boot from the virtual media. This feature, known as Serial over LAN, eliminates the need for an external serial console server. You are prompted to specify the device mode (SE, SR, or VOSM) and to configure the interface to be used for VDS-OS communication.



What is type 2 diabetes glucose level quickly
What kind of fruit can a diabetic eat rice
Gestational diabetes treatment medication 2014




Comments

  1. insert

    Time, it can be an annoyance and cause you to have not.

    22.05.2014

  2. 00

    Each scrumptious and satisfying will be few and much breads, and.

    22.05.2014